1 Energy and Environment Group, Department of Building, Civil and Environment Engineering, Concordia University, Montreal, Canada.
2 Exposure and Biomonitoring Division, Environmental Health Science and Research Bureau, Health Canada, Ottawa, Canada.
3 Energy and Environment Group, Department of Building, Civil and Environment Engineering, Concordia University, Montreal, Canada. Electronic address: Fariborz.Haghighat@Concordia.ca.

Photocatalytic oxidation is a promising technology to control air pollution. However, the formation of hazardous by-products hinders the commercialization application of this technology. This paper reports the development of a novel by-products predictive model considering the mass transfer of the pollutant in the gas phase and kinetic reaction in the solid phase. Two challenge compounds from ketone group (acetone and methyl ethyl ketone) were examined for model validation in a continuous Photocatalytic Oxidation (PCO) reactor with TiO₂ coated on silica fiber felts. A possible reaction pathway for degradation of each challenge compound was proposed based on identified by-products using analytical methods (GC-MS and HPLC). Formaldehyde, Acetaldehyde, Propionaldehyde, Ethanol, and acetic acid were detected as by-products of the Acetone and Methyl Ethyl Ketone in the PCO reactor. Different possible reaction rate scenarios were evaluated to find the best expression fitted to experimental data at the steady-state condition. The obtained reaction coefficients were then used to validate the model under various operating conditions, namely concentration, relative humidity, irradiation, and velocity variations. Higher concentration and irradiation, as well as lower relative humidity and velocity, resulted in more by-products generation. It was also observed that with enhancing residence time, mineralization efficiency (or CO₂ formation) and by-products generation increases through PCO reaction. The model validation provided acceptable accuracy for both steady-state and transient conditions. Finally, the Health Risk Index was used to investigate the implications of generated by-products on human health under varying operating conditions.